Synthseal® Interface Solutions Specifications

Specifications and Product Data
featured on this page:

D-8080, N-8092, N-8094, N-8090, S-8091
Synthseal® – for use up to 180°C (350°F)
Products Characteristics and Uses Density
g/cm³
(45 lbs./cu.ft.)
(min.)
ASTM F 36
Compressibility
% @ 34.5 MPa
(5000 psi)
Minimum
Recovery
%
ASTM F 152
Tensile
Strength
(MPa) psi
ASTM F 36 Oil No. 3 ASTM F 36 Fuel B Composition
Tensile
Loss
Maximum %
Thickness
Increase
Maximum %
Compressibility
%
Maximum
Weight
Increase
Maximum %
Thickness
Increase
Maximum %
Fiber Rubber
Binder
D-8080 D-8080 is a non-asbestos formulated gasket material designed as a direct substitute for compressed asbestos and asbestos-containing beater addition products. It is designed for low-to-moderate flange pressures at temperatures above 180°C (350°F) and is suitable for dry heat applications, electrical fixtures, and other light duty appliances. It can also be used as a radiant heat shield in applications where some degree of insulation is needed.
N-8092 Excellent crush resistance at high flange pressures. Nitrile binder. Recommended for sealing oil, fuels, and water up to 180°C (350°F). 1.20 (75) 15-30 35 11.0 (1600) 30 20 40 40 20 Reinforced Cellulose Nitrile Butadiene
N-8094 An economical material exhibiting very good crush resistance at high flange pressures. Recommended for sealing oils, fuels, and water up to 180°C (350°F). Fully Cured nitrile binder. .87 (54) 28-42 20 8.6 (1250) 30 7 45 50 7 Reinforced Cellulose Fully Cured
Nitrile Butadiene
N-8090 A reinforced fiber and Latent Cured nitrile binder composition with outstanding sealing characteristics. Excellent oil resistance. For applications up to 180°C (350°F). 1.28 (80) 15-25 35 13.8 (2000) 45 30 50 30 20 Reinforced Cellulose Latent Cure System
Nitrile Butadiene
S-8091 Seals oils, fuels, and low-pressure steam. Controlled-Swell with latent cure styrene binder. For applications up to 180°C (350°F). 1.20 (75) 15-25 25 12.4 (1800) 30-75 25-50 Reinforced Cellulose Latent Cure System
Styrene Butadiene
“Controlled-Swell”