Thermo-Tork® Interface Solutions Specifications

Specifications and Product Data
featured on this page:

TN-9000, TN-9001, TN-9004, TN-9005, TS-9006, TS-9003
Thermo-Tork – for use up to 400°C (750°F)
Products Characteristics and Uses Density
g/cm³
(45 lbs./cu.ft.)
(min.)
ASTM F 36
Compressibility
% @ 34.5 MPa
(5000 psi)
Minimum
Recovery
%
ASTM F 152
Tensile
Strength
(MPa) psi
ASTM F 36 Oil No. 3 ASTM F 36 Fuel B Composition
Tensile
Loss
Maximum %
Thickness
Increase
Maximum %
Compressibility
%
Maximum
Weight
Increase
Maximum %
Thickness
Increase
Maximum %
Fiber Rubber
Binder
TN-9000 Fully Cured binder, highly compressed material with good tensile strength, low creep relaxation, excellent fuel and oil resistance. For high flange pressure applications up to 400°C (750°F). 1.44 (90) 7-17 50 17.2 (2000) 35 10 30 20 15 Aramid Fully Cured
Nitrile Butadiene
TN-9001 A heavy-duty. Latent Cure material with nitrile binder for heavy-duty applications at elevated temperatures up to 400°C (750°F). Excellent oil resistance. 1.28 (80) 15-30 40 13.8 (2000) 40 20 35 30 30 Aramid Latent Cure System
Nitrile Butadiene
TN-9004 Cost-effective heavy-duty compressed material with Fully Cured nitrile binder. Excellent fuel and oil resistance. Good tensile strength. For high flange pressure applications up to 350°C (650°F). 1.50 (95) 5-20 45 17.2 (2500) 45 15 25 20 15 Aramid Fully Cured
Nitrile Butadiene
TN-9005 Cost-effective heavy-duty material Latent Cure system with nitrile binder. Good conformity for irregular flange surfaces. For applications up to 350°C (650°F). 1.28 (80) 15-30 20 10.3 (1500) 50 20 50 40 20 Aramid Latent Cure System
Nitrile Butadiene
TS-9006 Cost-effective heavy-duty compressed material with Fully Cured styrene binder. Recommended for use in oil, water, or steam. Good tensile strength. For service in high flange pressure applications up to 350°C (650°F). 1.50 (95) 5-20 40 10.3 (1500) 20-60 15-40 Aramid Fully Cured Styrene Butadiene
TS-9003 Controlled-Swell alternative to high-swell compressed asbestos materials. Latent cure styrene binder on heat-resisting thermally stable fibers offers good sealing characteristics at low flange pressures. Conforms well to irregular flange surfaces. For applications up to 350°C (650°F). 1.44 (90) 15-30 20 6.9 (1000) 45-85 20-50 Aramid Latent Cure System
Styrene Butadiene
“Controlled Swell”